Plastic Mould Temperature Controller Dual Zone OMT-910-W For Extrusion

OMT-W Mold Temperature Controller Water Heater.pdf...

Product Features of Water Heater Temperature Control

• Equipped with the design of one week automatic start/stop timer, screen can be converted between Chinese and English.
• P. I. D. multi-stage temperature control system can maintain a mold temperature with an accuracy of ±1^oC.
• Adopts high efficiency water cycle pump, which can meet the demands of temperature control for precise molds and mold loop with minor diameter to achieve precise temperature control and high efficiency heat exchange. Pump inside adopts stainless steel to avoid explosion.
• Multiple safety devices including power reverse phase protection, pump overload protection, overheat protection and low level protection that can automatically detect abnormal performance and indicate this via visible alarm.
• For standard OMT-W, the heating temperature can reach 120^oC, while for OMT-HTW, it can reach 180^oC.
• Equipped with high pressure protection, safety pressure relieving, automatic water supplying and air exhausting.
• For OMT-W, direct cooling is adopted. Automatic water supplying device ensures fast heat exchange.

Application of Water Heater Temperature Control

OMT-W series water heaters are widely used in the production of plastic product. They are mainly applied to heat up the mold and maintain temperature, also they can be used in other similar fields. Through the principle of heat exchange, they can shorten the product mold cycle and improve production efficiency.

PARAMETERS of Water Heater Temperature Control

Machine Details of Water Heater Temperature Control

Note of Maintenance

1) Turn off the main switch and control switch and unplug the cord from power supply before service and maintenance.

2) Be sure not to modify electrical wiring or reassemble the electrical components inside of the control box.

3) Always refer to the electrical diagram of this manual to check and maintain the electrical wiring problems.

4) Service and maintenance of the electrical parts should only be carried out by qualified electricians.